The Whirlpool Duet Washer F71 Error is a user interface heartbeat failure. It means the central control unit (CCU) is not detecting input from the user interface boards. Check the wiring between the user interface control boards and the central control unit for loose connections or damaged wiring.
What does F71 mean?
F71. means that there was not communication detected from the keypad to the central control unit. Attempt to return the washer to operation by following the. Hard Reset.
How do you clear the error code on a Whirlpool Cabrio?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
How do I fix error code F71?
Try unplugging the washer to completely disconnect electrical power. Wait 1 minute and then plug the washer back in to the see if the fault code clears. If the code reappears, then you could have a wire harness connection problem, a failed user interface control board or a failed central control unit.” from here.
What does F71 mean on a boiler?
What does the F71 fault code mean on my Vaillant boiler? According to Vaillant, the F71 fault code will be displayed on your boiler’s control panel when there’s an issue with the NTC thermistor. The PCB has noticed that on firing up, there’s been no recorded temperature change.
How do you manually drain a Whirlpool Cabrio washer?
Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.
What is the F70 code on Whirlpool washer?
The F70 error on this model washer is a central control unit (CCU) heartbeat failure. This means there is communication loss from the central control unit and the user interface. If all the wiring and connections look good and the drum on the washer rotates replace the user interface.
How do I fix error code F72?
The process to clear the fault code is simple:
- Employ a qualified gas engineer.
- Isolate the problem to limescale build-up.
- Replace the thermistors.
- Dose the heating system with inhibitor (to break down limescale)
- Fit a scale reducer (a filter to catch limescale deposits)
- Reset the boiler to clear the F72 fault code.
