Flush bulb with water before each use.
- Push pipe into bulb.
- Squeeze bulb to expel air, submerge tip in warm water or mixed enema preparation.
- Release pressure on bulb slowly to full.
- Lubricate tip.
- Positions: A) To use in bathtub, recline on side with knees drawn up; B)
- Gently insert pipe into rectum up to flange only.
How do you use a syringe bulb for constipation?
Gently and slowly insert the tube into your rectum, relaxing your muscles and allowing your anus to push out so that it enters more easily. Only insert the tube up to four inches into your rectum. Give the fluid time to drain into your rectum. Take slow, deep breaths and relax until the bag empties.
How far do you insert the tip of an enema?
Remove the cap from the nozzle of the enema. Gently insert the tip of the nozzle into the anus, and continue inserting it 10 centimeters (3–4 inches) into the rectum. Slowly squeeze the liquid from the container until it is empty, then gently remove the nozzle from the rectum.
How much water should I use for an enema?
Fill the enema bag with 500 cc (about 2 cups) warm tap water. Do not use hot water. 2. Hang the enema bag on a nail or hook or have someone hold it about 12 to 18 inches above your rectum.
Can you give yourself an enema with a syringe?
The typical enema that a doctor may use contains a saline solution. They mix the solution and inject it into the rectum using a large syringe or tube. Homemade enemas typically contain clean distilled water mixed with another substance, such as: castile soap.
Why do you lay on your left side for an enema?
Position the patient on left side, lying with the knees drawn to the abdomen (Fig 2). This eases the passage and flow of fluid into the rectum. Gravity and the anatomical structure of the sigmoid colon also suggest that this will aid enema distribution and retention.
Can I just use water for an enema?
What are the different types of enema solutions? of salt and water. The salts in this enema pull water from the body into the bowels to soften the stool. You should never use plain water in an enema.
Is it safe to enema with tap water?
Although dangerous electrolyte abnormalities are rare, potential morbidity in those cases warrants periodic evaluation. Due to the elevated sodium content in softened tap water families should be alerted to use untreated tap water for preparing enemas.
How do you administer an enema with a syringe?
Fill the syringe with warm or room temperature enema liquid, if it is not prefilled. Remove any covering over the tip and lubricate with petroleum jelly or a water soluble lubricant. Gently insert tip into rectum, no more than two inches, and squeeze bulb to administer liquid. Remain on your side…
How much water do you put in an enema bulb?
Fill the bulb with warm water. The water should be slightly above body temperature or approximately 103 degrees Fahrenheit. The bulb can hold eight ounces of the water. If using an enema solution recommended by a doctor, follow the instructions for this product.
How to sterilize enema syringe (Higginson)?
Instruction Manual for Enema Syringes (Higginson) Sterilize the Enema Higginson Syringe by keeping them in luke warm water for 3-4 hours (overnight). Dip back-end of Enema Syringe in Water Jar or connect with a tube/tap. Prepare yourself for enema. (Please ensure that you are in a good health and are able to carry enema activities.) Press…
How do you lubricate an enema bag?
Coconut oil or olive oil to use as a lubricant on the tip of the enema bag or bulb syringe and on the opening of the anus. Filtered Chlorine–Free Water, at body temperature – 1 quart (1 liter). Do not use chlorinated water since it will destroy the intestinal flora inside your colon.
